|
Quantity
|
Total
|
||
|
|
|||
|
|
|||
Features of ItalWax Plum Wax:
- due to high plasticity, it is evenly applied and smoothly distributed, following the anatomical curves of the body;
- provides maximum adhesion to all hairs, including hard and short ones;
- forms a thin film that is easily removed;
- density is average;
- solidification time – 10-13 seconds;
- working temperature –about 40C°;
- minimizes the risk of redness and irritation;
- has a pleasant fruity aroma.
Method of application:
- Heat the wax to a working temperature of 40-42 degrees.
- Treat the depilation area with an alcohol-containing lotion.
- Apply a small amount of talc.
- Apply a layer of wax with a spatula regardless of the direction of hair growth, but in the direction of yourself, leaving a small "petal" that can be grabbed later. The wax hardens after 4-12 seconds, during which time the wax manages to completely capture all the hairs (wax ready for removal should not stick to the hand when touched).
- Having previously stretched the skin in the direction opposite to the tear, with a sharp jerk remove the wax from yourself parallel to the skin. Repeat the procedure on the next section.
- After depilation, treat the skin with a soothing, cooling, oil-free product: cooling cream/gel, lotion.
Please note that incorrect or improper use of the product may harm your health. Non-compliance with the temperature regime can lead to the violation of each cover.
Main mistakes when using film wax:
The wax stretches like caramel and is difficult to remove. The reason: the wax did not harden. Solution: dry the wax with talc, wait 2-3 seconds and remove.
After removing the wax, hairs remained. The reason: the spatula with wax was not sufficiently pressed against the skin, so the hairs did not get into the layer of wax. Solution: apply wax to the area of skin with the remaining hairs, pressing the spatula tighter to the depilation area.
After removal, the wax around the edges of the application remains on the skin. Reason: uneven application of wax. Solution: form an application with the same layer in the middle and on the edges.